I use the omniprn program that allows Omnigo printing via a PC to a laserjet. I
noticed that when my batteries were low, especially on the higher baud rate of
19200, there was a lot of noise and incorrect printing. If I used fresh high
quality alkalines, the printing improves, but is still not perfect. If I use an
AC adaptor, the printing is great even at the high transfer rate of 19200 bps.
It seems like the serial data quality is linked to the power level in the
batteries. How can this be since both sender and target are digital? Does this
occur with other applications that use the serial cable such as Installer and
the Connectivity Pack?
Any clues? Thanks.
Jeff Hinman
ust941@edcca4.bgl.ca.boeing.com