Fri, 27 Jun 1997 23:42:23 -0400 (EDT)

A hard reset (small paper clip in the hole on the "bottom") does not reset
any files
in the Omnigo. This method DOES NOT restore your autoexec.bat. It resets
the hardware. There are only two ways to reload the software. One is to
reboot (hard or soft) and hold down the 'C' key during boot. The other is to
remove ALL the batteries. The results of these two methods are identical.
All software and data files are returned to factory condition. UNLESS...
the ROM is corrupt. Then you need to find a repalcement Ogo.

However, the hard reset may clear problems with software that sets hardware
settings. In hard resetting the Ogo it may actually clear a software "hang"
that expects the hardware to be in a certain state when it loads.